What E8 Means
WHICH MACHINES THIS APPLIES TO: the E-series belongs to the Asko Logic, Pro Home, Craft and Elements washers - models such as W2084, W4086, W6088X and the WM75 series. On these the display shows "Error" and the number; holding the INFO button brings up the description text, and EXIT returns to the main menu. The earlier W6xxx machines do not use E-codes at all; they show F10, F11 and F12, which are separate entries here.
WHAT E8 MEANS: the description text is "SPINNING ERROR". Asko's published action is "Turn the appliance OFF and then switch it again ON. Start the program again. If the error reoccurs, call service technician."
WHAT THE MACHINE WAS DOING: a spin is the most demanding thing a washer does. The control has to get the drum up to speed while the load is still shifting, hold it there, and monitor it the whole time. A spinning error is raised when that does not go the way the control expects - which is not the same as the drum refusing to move, and is why Asko asks for a power cycle and a retry before anything else.
THE CODES NEXT DOOR: the same table carries E13.1 for an unbalance with an empty drum, E13.2 for an inertia error, and the plain-text UNBALANCE alert, all of which are about how the load is sitting rather than about the machine. If your laundry came out soaking and the display said something about unbalance rather than spinning, that is a different entry with a much simpler answer.
CLASSIFICATION: fault. One power cycle is the manufacturer's response; after that it is a service matter.
Common Causes of E8
- Load badly distributed or a single heavy item on its own
- Machine not level or standing on a foot that is not touching the floor
- Motor, drive belt or motor control fault
- Tacho or speed sensing fault
- Drum bearings or suspension worn
🔧 One Safe Check You Can Try
Switch the appliance off, switch it on again and start the programme, exactly as the manual says. Before you do, take thirty seconds on the two things that produce spin problems and cost nothing: open the door and spread the load out in loose heaps around the drum instead of one lump on one side, and check the machine is standing firmly on all four feet with nothing rocking - a washer that moves on an uneven floor cannot complete a high-speed spin cleanly. If the error returns after that, stop and call. Do not run the spin repeatedly to see whether it eventually takes; a machine that raises a spinning error is reporting something about a drum that has been up to speed, and the motor, the drive and the drum suspension are all inside a cabinet that has to be isolated from power before it is opened.
⚠ Why You Shouldn't Go Further Than That
- The motor, drive and suspension sit inside the cabinet and the machine has to be isolated at the outlet or the breaker before any panel is removed.
- A drum that has been spinning at speed keeps turning after the cycle stops, so nothing is reached into until it has come to a complete standstill.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.