What E6 Means
WHICH MACHINES THIS APPLIES TO: the E-series belongs to the Asko Logic, Pro Home, Craft and Elements washers - models such as W2084, W4086, W6088X and the WM75 series. On these the display shows "Error" and the number; holding the INFO button brings up the description text, and EXIT returns to the main menu. The earlier W6xxx machines do not use E-codes at all; they show F10, F11 and F12, which are separate entries here.
WHAT E6 MEANS: the description text is "HEATING ERROR", given in some editions as "Water heating error." Asko's published action is "Restart the program. If the error reoccurs, call a service technician."
WHAT THE CONTROL IS ACTUALLY JUDGING: a washing machine does not measure the element directly. It switches heating on and then watches the temperature, and if the temperature does not move the way it should within the time it allows, it raises a heating error. That means this code covers a failed element, but it also covers anything that stops the water getting warm on schedule - which is why Asko's own first response is a restart rather than a parts list.
WHAT YOU WILL NOTICE: washes that finish cold, or a cycle that stops partway through at the point where heating should have begun.
CLASSIFICATION: fault. Restart once, as the manual says, and then it is a service matter.
Common Causes of E6
- Heating element failed or open circuit
- Temperature sensor reporting incorrectly so the rise is never confirmed
- Element wiring or connector damaged
- Control unit not switching the heating circuit
- Water level too low for the element to be covered
🔧 One Safe Check You Can Try
Restart the programme once, which is the manufacturer's instruction. If it fails again, the useful work is observation rather than access. Note whether cold programmes run through to the end while heated ones stop - that distinction alone tells a technician a great deal. Note at what point in the cycle it stops, and whether the drum water is warm at all when it does. Note whether the machine is on a cold fill or a hot fill, because a hot-fill machine whose hot supply has been turned off behaves very like one with a heating problem. Do not open the cabinet to look at the element: it is a mains-voltage component with its terminals at the back of the drum, the machine has to be isolated at the outlet or the breaker before anything is removed, and on a front-loading washer getting there means dismantling round a suspended drum.
⚠ Why You Shouldn't Go Further Than That
- The heating element is a mains-voltage component and its terminals are inside the cabinet, so the machine has to be isolated at the outlet or the breaker before anything is opened.
- On a front-loading washer the element is reached by dismantling around a spring-suspended drum, which is not comparable to cleaning a filter.
Opening a panel to inspect or repair something yourself doesn't automatically cancel your manufacturer's warranty — but it can risk accidental damage, and some manufacturers do have specific service conditions. Check your product's warranty terms, or ask us, before deciding.